This pallet bar was actually on the smaller side. Only about 6′ in length so coming up with the wood (about three pallets) was simple. I cut one of my pallets in half and attached each half to the sides of a full pallet to make the base. I then built a simple frame and attached some boards to form the top.
As you can see, I chose to go in two directions just to give it a little flare! Now as far as the stools go, I can’t take any credit for those. My customer found them on a social media site and liked them so; I just went with it. So thank you to whoever built them originally!
This was a pretty easy build. I mean with a circular saw and screw gun and a wee bit of glue, not bad for a couple of days work. I didn’t add any finish because the customer liked the natural look of the wood. So naked it stayed!
Thanks for reading and looking and any feedback is welcome.